This site uses and sets "cookies" on your computer to help make this website better. You can learn more about these cookies and general information about how to change your cookie settings by clicking here.By continuing to use this site without changing your settings, you are agreeing to our use of cookies.

Learn More About Cookies On perflexgroup.com

CRYSTAL EPOXY RESIN

Crystal Epoxy ResinPerflex P-128 is high permeability epoxy pouring adhesive cured at room temperature. It has the advantages of good transparency, low viscosity, environmental protection and mild curing process. After curing, it has high transparency, good hardness and excellent yellowing resistance.

Model Number：P-128

Component：epoxy resin

Certificate：France A+, CE, Rohs, ISO9001

Volume： loaded with 5kg in 5L plastic barrel

Shelf life：24 months

Appearance：clear liquid

Application：Insulation sealing of wood crafts, decorative surface gum dropping, furniture and mould filling, especially suitable for filling with high thickness requirements such as river tables, tea trays and wooden furniture.

Color
Toning Dosage
Calculator Operation
Video

lnquiry Online

Main Features:

It is a high permeability epoxy pouring adhesive, cured at room temperature. It has the advantages of good transparency, low viscosity, clean taste, environmental protection and mild curing process. After curing, it has high transparency, good hardness and excellent yellowing resistance.

Application:

Perflex crystal epoxy resin can be used for the insulation sealing of wood crafts, decorative surface gum dropping, furniture and mould filling, and other electronic parts. It is especially suitable for filling with high thickness requirements such as river tables, tea trays and wooden furniture.

Technical Parameters:

	Base resin	Hardener
Appearance:	clear liquid	clear liquid
Specific gravity	1.15±0.01	0.96±0.01
Flash point	>140℃	>140℃
Viscosity (25℃*cps)	480-580	35-50
Mix proportion (weight ratio)	A:B=3:1
Curing time(100g25℃min)	48min
Condition of cure	60～70℃×2h or 80℃×1h
Flexural strength(unit: kg/mm2)	14
Tensile strength(unit: kg/mm2)	7
Elongation(unit:%)	3.6
Hardness(Shore D)	75
Water absorption 25℃/24h(unit:%)	＜0.1

Cautious:

1-Keep the bonding surface clean and dry, free of dust and grease.

2-Ensure to mix the 2-component adhesive by weight ratio, and stir well. Adjust the amount of mixture based on operation speed and ambient temperature.

3-When the relative humidity reaches over 80%, it is recommended to cure by adding heat rather than at room temperature.

4-If permitted, vacuum degassing before applying produces better results.

5-Excess adhesive can be cleaned off with a rag dipped with small amount of alcohol or acetone before fully curing.

6-Close the lid of the container well after use to minimize moisture entering into the container causing quality issue.